Skip to main content
Skip table of contents

Vertex G4 does not start ( Entry Point Not Found )


Vertex G4 does not start. An error message appears, The prosedure entry point could not be located in the dynamic link library.


The problem is caused by the operation of the antivirus program. Antivirus program blocks VERTEX64.exe from starting. The solution is to put the VERTEX64.exe in the applications allowed in the virus checker.

If this does not solve the problem, please contact to Vertex Helpcenter 03 3134 1300.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.